Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
They can be installed, placed inside the house or buried outside.
The tanks of the stations are made from high density polyethylene and have a high mechanical resistance, are odour-resis-
tant, UV-resistant and resistant to chemical attack. Their lid is screwed and held in place by a safety screw (not provided).
The tanks of the stations are delivered with 1 or 2 pumps depending on the model.
These tanks have several inlets of different diameters for the inlet of the effluents, or drilling zones.
These devices comply with the EN 12050-1 standard (pumping station for waste water containing faeces) as well as the
European directives on construction products, electrical safety and electromagnetic compatibility.
DoP available on our website in the product page.
They must be installed in accordance with standards EN 12056-4 for indoor installation and EN 752 for outdoor installation.
3.2 SCOPE OF SUPPLY (SEE ATTACHED LEAFLET)
SANIFOS® 110
On a pallet:
• Sanifos® tank 110 litres, cover and gasket
• Hydraulic to be assembled
Note:
• The shut-off valves and the non-return valve are not supplied (available as an option, ref = KITEVACSANIFOS110).
• Sanifos® 110 is provided with a cover supporting up to 200 kg.
SANIFOS® 280
On a pallet:
• Sanifos® tank 280 litres with cover and sealing ring
• Hydraulic pre-assembled in the tank with shut-off valve and non-return valve.
A 30 cm height extension is available for the Sanifos® 280.
SANIFOS® 610
On a pallet:
• Sanifos® 610 litre tank with cover and sealing ring
• Hydraulic pre-assembled in the tank with shut-off valve and non-return valve.
A 40 cm height extension is available for Sanifos® 610 .
SANIFOS® 1300
On 2 pallets:
• Sanifos® 1300 litre tank with cover and gasket
• Hydraulic pre-assembled in the tank with shut-off valve and non-return valve.
A 40 cm height extension is available for Sanifos® 1300.
3.3 RATING PLATE
1
8
3.4 DESIGN AND OPERATING MODE
The pumping station is equipped with several horizontal inlet openings or drilling zones, for 40/50/100/110/125 mm exter-
nal diameter piping (depending on the model).
The motor-pump assembly conveys the pumped fluid in the discharge pipe.
The ventilation duct (external diameter 75 mm, or 100 mm on the Sanifos® 1300) allows the tank to always remain at
atmospheric pressure (1 ventilation hole on the Sanifos® 110, Sanifos® 280, Sanifos® 610 and 4 ventilation holes on the
Sanifos® 1300 pumping station).
3
2
4
5
6
9
7
1
Name of the pumping station
2
Power consumption of the engines
3
Supply voltage
4
Frequency
5
Protection index
6
Date of production
7
Identification number
8
Max height
9
Max flow rate
EN
23
Advertenties
Hoofdstukken
Inhoudsopgave
