Description Of Functions; Technical Data; Charging Time - Parkside Pmsa 20-Li A1 Vertaling Van De Originele Gebruiksaanwijzing
Inhoudsopgave
Beschikbare talen
Beschikbare talen
GB
IE
NI
22 Filter holder
Fig. B
23 Elongated pin
24 Mount (Sanding disc)
25 Pin
26 Delta sanding disc
27 Delta sanding plate
28 Clamping lever (Sanding disc)
29 Round sanding plate
30 Clamping lever (Sanding plate)
31 Finger sanding plate
32 Clamp
33 Oscillating sanding disc
Description of functions
The multi-sander has a rotating or oscil-
lating sanding disc for processing wood,
metal or paint.
Please refer to the descriptions below for
information on how the operating ele-
ments work.
Technical data
Cordless Multi Sander 20V
.............................. PMSA 20-Li A1
Rated voltage U ............................. 20 V ⎓
Weight with battery (20 V, 2 Ah) ... 1.7 kg
No-load rotation speed n
....................................4000–10000 min
Idle vibration frequency n
....................................8000–20000 min
Orbit diameter
– Eccentric sanding disc ................ 2.5 mm
– Delta sanding disc ......................1.8 mm
– Oscillating sanding disc ............. 1.9 mm
Sound pressure level (L
...................................... 80.4 dB; K
Sound power level (L
..................................... 88.4 dB; K
Vibration (a
) .. 10.013 m/s²; K=1.5 m/s²
h
6
0
−1
−1
)
pA
=3 dB
pA
)
WA
=3 dB
WA
Battery ................................................. Li-Ion
Temperature ................................... ≤50 °C
– Charging ................................4 – 40 °C
– Operation ......................... −20 – 50 °C
– Storage .................................. 0 – 45 °C
PARKSIDE Performance Smart battery
Smart PAPS 204 A1/Smart PAPS 208 A1
– frequency band .... 2400–2483.5 MHz
– transmitted power ................... ≤ 20 dBm
Levels of noise and vibration were determ-
ined according to the standards and regu-
lations in the declaration of conformity.
The specified total vibration value and the
stated noise emission value have been
measured according to a standardised
test method and can be used to compare
one power tool with another. The specified
total vibration value and the stated spe-
cified noise emission value can also be
used for a provisional assessment of the
load.
WARNING! The vibration and noise
emissions may deviate from the specified
values during actual use of the power tool,
depending on how the power tool is be-
ing used. Try to keep the exposure to vi-
brations as low as possible. An example
of a measure to reduce vibration exposure
is limiting the working hours. All parts of
the operating cycle have to be considered
while doing so (for example, times when
the power tool is switched off and times
when it is switched on but running without
any load).
Charging time
The device is part of the X 20 V TEAM
series and can be operated with bat-
teries of the X 20 V TEAM series. Bat-
teries of the X 20 V TEAM series may
only be charged using chargers of the
X 20 V TEAM series.
We recommend that you operate
this appliance with the following bat-
Hoofdstukken
Inhoudsopgave
