Inhoudsopgave
Advertenties
3. The distance between the holes must be 31.5 cm
(see Figure 3).
4. The distance to the walls must be at least 30 cm.
5. The distance to the ceiling must be at least 45 cm.
6. The distance to the floor must be at least 2m (see
figure 4 and 7).
7. The distance to the bathtub / shower tray should
not be less than 60 cm (see figure 7).
Please note: If the predefined distances cannot be
complied with, the device should not be mounted.
Please note: You may probably need a climbing aid
(e.g. a ladder) for you to be able to carry out the
installation.
3
4
5
Setzen Sie das Heizgerät auf die Befestigungs-
schrauben
(siehe Bild 5).
I
Achten Sie darauf, die Befestigungsschrauben
in das Loch
einzuführen (siehe Bild 6).
I
34
GB/IE/NI
Bewegen Sie nun das Heizgerät nach rechts und
dann nach unten zur Position
6
Install
Starting up
Connect the fan heater to a grounded and secured
socket. To supply the electric current to the device,
turn the ON/OFF switch
device is now at the standby mode. Its display shows
the ambient temperature.
Now you can turn the fan heater ON and OFF, as
follows:
On the control panel: Press the On/Off button
on the control panel. The device will start. To
E
switch off the device, press the On/Off button
on the control panel five times consecutively.
Please note: If necessary, a climbing aid is required to
press the ON/OFF button
on the device.
G
With the remote control unit: Press the ON/OFF
button
on the remote control unit. The unit starts.
1
To turn the unit OFF, press the ON/OFF button
on it once more.
Please note:
If you turn the unit off, the fan will still run 30 seconds.
Then the unit will switch off. A countdown is shown on the
display (only after heating function).
TURNING OFF
To turn the device off, please press the
ON/OFF button
unit. To disconnect the fan heater from the po-
wer supply, set the ON/OFF switch
position ' '.
.
B
Uninstall
A
to the "I" position. The
H
or the start/stop button
H
on the remote control
1
H
E
1
to
Advertenties
Hoofdstukken
Inhoudsopgave
