Inhoudsopgave
Advertenties
Control via the control panel
A
F
E
D
Note: The device can be switched on and off via the
control panel. The heating level and timer settings can
also be changed.
Explanation of the functions
SETTING OF HEATING LEVELS
Pressing the heating level button
to switch the ceramic wall fan heater on/
off as well as to set the desired heating
level. By pressing the button
control panel, the device will change to
the next heating level. Depending on the
choice of the heating level the respective
indicator will light up on the display panel.
Press 1x: Fan mode
Press 2x: 1. Heating level (1000 W)
Press 3x: 1. Heating level (1000 W)
with Oscillation
Press 4x: 2. Heating level (2000 W)
Press 5x: 2. Heating level (2000 W)
with Oscillation
Press 6x: Switching off
TIMER SETTING
The purpose of the timer is to automatically
turn off the ceramic fan heater.
With the aid of the timer, you can select the turn-off time
in hour increments. Then the wall-mounted ceramic fan
heater will switch off automatically.
Please note: As long as a weekly timer is activated,
the turn-off timer cannot be used (see chapter "Deac-
tivation of the Week Timer).
B
Turn the device ON (see Starting). Press the timer but-
C
ton
repeatedly until you reach the desired number
C
of hours.
Example: If the device should automatically switch off
after 4 hours, press the timer button
„4H" on the display. Wait about 5 seconds. The in-
formation is automatically transferred. Then the device
will be automatically turned off in 4 hours. If you want
to make sure that the timer entry has been transferred,
press the timer button
entry will appear in the display.
serves
By repeatedly pressing the timer button
E
will be adjusted in 1-hour increments:
0H – 1H – 2H – 3H – 4H – 5H – 6H – 7H – 8H
on the
E
Control using the remote control
Please note: All functions of the device are controlled
using the remote control. The corresponding symbol
will light up on the display panel when the function
is activated.
Explanation of the functions
TEMPERATURE SETTING
once more. Then '4H' or your
C
When setting the temperature, please note
that the device does will not heat, if the desi-
red temperature is not higher than the ambi-
ent temperature. To enable heating, the set
temperature needs to be at least 1°C higher
than the ambient temperature. The latter is
automatically displayed when the device is
turned on. After successful temperature set-
ting, the symbol appears on the display. The
fan continues to run.
until you see
C
, the timer
C
GB/IE/NI
35
Advertenties
Hoofdstukken
Inhoudsopgave
