Inhoudsopgave
Advertenties
4. Confirm your selection by pressing the
OK button
.
5
5. Now the display now shows the number of hours
(00). By pressing the plus
tons, you can adjust the desired number of hours
(00-23).
6. Confirm your selection by pressing the
OK button
.
5
7. The display now shows the number of minutes
(00). By pressing the plus and
, you can adjust the desired number of minutes
7
(00-59).
8. You can save your settings by pressing the
OK button
and then exit the menu.
5
9. As soon as you have set the system time, „P1"
appears in the display.
10. Wait 10 seconds without pressing any button.
Then the system settings will be accepted by the
system. The ambient temperature is shown on the
display. If necessary, you can continue selection
of programs: P1, P2... P6. For more information,
see Chapter "Week Timer".
Please note: to reset the system time, you have to
turn off the device and disconnect it from the po-
wer supply.
WEEKLY TIMER
The purpose of the week timer is to
automatically switch the wall-mounted
ceramic fan heater on and off at specific
times. To set the week timer, you have
5 pre-set programs available. Moreo-
ver, you have also a program to be set
manually. As soon as the function is acti-
vated, the device automatically switches
on or off according to the respective
time table.
Please note: It is not possible to start the week timer,
as long as the device is at the fan mode.
Please note: To adjust the week timer, you have to set
the system time first (see 'System Time Setting').
and minus
but-
8
7
minus buttons
8
SETTING THE TIMER PROGRAMS, 1-5 (PRE-SET
PROGRAMS)
1. Switch on the device (see Putting into operation).
2. Select the first or the second heating level. To
do so, press the heating level button
symbol lights up on the display. See Chapter
A
"Heating Levels Setting". Alternatively, you can
select a desired temperature (see chapter "Tem-
perature Setting").
Please note: The wall-mount ceramic fan heater will
be turned ON depending on the selected program
and run the last heating level or temperature you
selected.
3. Press the week-timer button
4. Then the timer program is shown on the display.
With each pressing the button
to the next program - P1-P2-P3-P4-P5-P6-OFF
(see Program Table on the fold-out rear side).
5. Confirm your selection by pressing the
OK button
.
5
6. Depending on the programme selected in item
4 and depending on the time (day and time),
the weekly timer indicator will light up or flash
on the display panel.
If values
and
are lit continuously, the selected
A
B
program is active or the device turns off automatically.
If values
and
are flashing, the selected program is
A
B
not active. Then the device switches off after 30 seconds
again. In the meantime, the fan runs until the standby
mode. Values
and
A
B
gram automatically intervenes and turns the device on.
. The
11
:
9
, you will switch
9
continue to blink until the pro-
GB/IE/NI
37
Advertenties
Hoofdstukken
Inhoudsopgave
