Inhoudsopgave
Advertenties
TROUBLESHOOTING
Troubleshooting table
SYMPTOM
Text appears in the display
when the appliance is
connected for the first time.
The fan runs on for several
minutes after the hob has been
switched off.
A slight smell is noticeable the
fi rst few times the hob is used.
You can hear a ticking sound in
your hob.
The pans make a noise while
cooking.
You have switched a cooking
zone on but the display keeps
fl ashing.
A cooking zone suddenly stops
working and you hear a signal.
If the appliance does not work properly, this does not always mean
that it is defective. Try to deal with the problem yourself fi rst by
checking the points mentioned below or check for more information
the website 'www.atag.nl'.
Attention
If the square red light above the
malfunctions below apply) please contact the service departement.
POSSIBLE CAUSE
Th is is the standard set-up
routine.
The hob is cooling down.
The new appliance is heating
up.
Th is is caused by the capacity
limiter on the front and back
zones. Ticking can also occur at
lower settings.
Th is is caused by the energy
fl owing from the hob to the
saucepan.
Th e pan you are using is not
suitable for induction cooking
or has a diameter of less than
12 cm.
Th e preset time has ended.
GB 31
button fl ashes (and none of the
SOLUTION
Normal operation.
Normal operation.
This is normal and will disap-
pear once it has been used a
few times. Ventilate the
kitchen.
Normal operation.
Th is is caused by the energy
fl owing from the hob to the
saucepan. Th is is not harmful
for the pans or hob.
Use a suitable pan (see page 13
and 14).
Switch the bleep off using the
or
button on the timer.
General
Advertenties
Hoofdstukken
Inhoudsopgave
