Inhoudsopgave
Advertenties
TROUBLESHOOTING
SYMPTOM
Th e hob is not working and
nothing appears in the display.
A fuse blows as soon as the hob
is switched on.
Fault code F00 / Red indicator
light next to button
burning and the indicator light
above button
is blinking.
Fault code F0 ... F6 and FC.
Fault code F7.
Fault code F8 and F08 /
Red indicator light next to
button
is burning and the
indicator light above button
is blinking.
Fault code F9 and/or
continuous beep.
Fault code F99 / Red indicator
light next to button
burning and the indicator light
above button
is blinking.
Fault code FA.
Fault code FAN.
Other fault codes.
POSSIBLE CAUSE
Th ere is no power supply due
to a defective cable or a faulty
connection.
Th e hob has been wrongly
connected.
Th e control panel is dirty or has
is
water lying on it.
Defective generator.
Th e ambient temperature is not
good.
Appliance over heated.
Th e appliance has been
connected incorrectly and/or
the mains voltage is too high.
You have pressed two or more
is
buttons at the same time.
Mains voltage is too low.
Air circulation not good.
Defective generator.
GB 32
General
SOLUTION
Check the fuses or the electric
switch (if there is no plug).
Check the electrical
connections.
Clean the control panel.
Contact the service department.
Switch off all heat sources in the
vicinity of the cooking plate.
Th e appliance has been
switched off because of over
heating. Let the appliance cool
down and start again on a lower
setting.
Let your connection be
changed.
Do not operate more than one
button at the same time.
Contact your energy supplier.
Make sure the venting holes
under the cooking plate are open.
Contact the service department.
Advertenties
Hoofdstukken
Inhoudsopgave
