Atag HI311M Gebruiksaanwijzing pagina 46
Beschikbare talen
Beschikbare talen
faults
what should I do if...
If the appliance does not work properly, this does not always mean that it is defective.
Try to deal with the problem yourself first. Phone the service department if the advice
given below does not help.
fault
cause
The appliance does not work
No electricity.
and the lights are not on.
The hob does not work.
The appliance has been
F9 appears in the display.
connected incorrectly.
The hob does not work.
Ambient temperature was
F0 appears in the display.
too low (5 °C) when the hob
was not connected to the
electricity supply.
The fan switches on
The appliance is checking
spontaneously.
itself after a power failure.
The cooking zone suddenly
Insufficient ventilation.
switches off.
Message F7 appears.
Overheating of the
electronics in the hob.
The lights keep blinking after
Unsuitable pans.
switching on.
Poor electrical contact.
Appliance does not work.
Appliance is locked.
The appliance switches off.
Two pans are touching each
other or a pan comes into
contact with the wall.
GB 16
solution
Check the electrical
installation (main fuse(s),
connection).
Ask the installer to connect
the appliance again in
accordance with the wiring
diagram.
Wait for about ten minutes
after connecting. The
message disappears.
The fan switches itself off.
Check the ventilation
openings.
Let the appliance cool down.
Press any button and the
message disappears. Start
again on a lower setting.
Use a suitable pan (see pages
21 and 22).
Check whether the cable has
been knocked against by the
drawer. In that case, have the
connection changed by the
installer.
Press the key symbol
for three seconds
continuously.
Make sure that the pans
stand clear.
switching the beep off/on
The beep, which can be heard when the buttons are pressed,
can be switched off or on.
switching the beep off
1
Switch the front-left cooking zone on and then off by
pressing the on/off button twice.
on/off button front-
2
Immediately afterwards, press the – button belonging to
left cooking zone
the front-left cooking zone for five seconds.
A beep confirms the setting that has just been selected.
The beep for the front-left and rear-left cooking zones is now
switched off.
Repeat this operation for the right-hand cooking zones using
the on/off button and the – button for the front-right cooking
– button for front-left
cooking zone
zone.
switching the beep on
1
Switch the front-left cooking zone on and then off by
pressing the on/off button twice.
2
Immediately afterwards, press the – button belonging to
the front-left cooking zone for five seconds.
A beep confirms the setting that has just been selected.
The beep for the front-left and rear-left cooking zones is now
switched on.
Repeat this operation for the right-hand cooking zones using
the on/off button and the – button for the front-right cooking
zone.
extra facilities
beep
GB 17
