Stihl RME 339.0 C Handleiding pagina 28
English
■ If the lawn mower or blade is not maintained
or repaired correctly, components may no lon‐
ger operate correctly and safety devices may
be disabled. This may result in serious or fatal
injury to people.
► Do not maintain or repair the lawn mower
yourself.
► If the lawn mower needs to be maintained
or repaired: consult a STIHL specialist
dealer.
► Maintain the blade as described in this
instruction manual.
■ The user may cut themselves on sharp cutting
edges during blade cleaning, maintenance or
repair. This may result in injury to the user.
► Wear protective gloves.
■ The blade may become hot during sharpening.
This may result in the user burning them‐
selves.
► Wait until the blade has cooled down.
► Wear protective gloves.
■ The blade on the lawn mower is movable even
when the engine is switched off. During main‐
tenance of the blade, the user may be injured
by the moving blade.
► Work carefully.
► Wear protective gloves.
■ The blade on the lawn mower is movable. Dur‐
ing blade maintenance, the user may trap their
fingers between the moving blade and fixed
parts of the lawn mower.
► Work carefully.
► Wear protective gloves.
5
Preparing the Lawn Mower
for Operation
5.1
Preparing the Lawn Mower for
Operation
The following steps must be performed before
commencing work:
► Remove packaging material and transport
locks.
► Make sure that the following components are
in safe condition:
– Lawn mower,
– Blade,
4.6.2.
► Clean the lawn mower,
► Check the blade,
► Attach the handlebar,
► Fold up the handlebar,
► Connect the mains plug of the lawn mower to
an extension cable,
28
4.6.
14.
9.2.
6.1.
6.2.1.
7.
5 Preparing the Lawn Mower for Operation
► Plug the mains plug of the extension cable into
an easily accessible socket.
► If mowing and the mown grass is to be collec‐
ted in the grass catcher box: attach the grass
catcher box,
6.3.3.
► If mowing and the mown grass is to be ejected
to the rear: detach the grass catcher box,
6.3.4.
► Set the cutting height,
► Check the controls,
► If the steps cannot be performed: do not use
the lawn mower and consult a STIHL special‐
ist dealer.
6
Assembling the Lawn
Mower
6.1
Attaching the Handlebar
► Switch the lawn mower off.
► Detach the extension cable connector from the
mains plug of the lawn mower.
► Place the lawn mower on a level surface.
► Press sleeve (1) into the bores in upper han‐
dlebar (2).
► Fit spring washers (3) with the convex side
facing inwards onto sleeve (1).
► Guide upper handlebar (2) into handlebar
bracket (4).
► Push bolt (5) through the bores in handlebar
bracket (4) and the sleeve in upper handle‐
bar (2).
► Place nut (6) in the notch in handlebar
bracket (4).
10.2.
9.
0478-121-9926-A
