Parkside PWD 25 C4 Vertaling Van De Originele Gebruiksaanwijzing pagina 27
Beschikbare talen
Beschikbare talen
ate loss of any warranty
claim.
The device may only be
•
opened by an authorised
electrician. Always con-
tact our service centre for
repairs.
Switch the drive off, dis-
•
connect the device from
the power supply and al-
low the device to cool off
if you want to clean, ad-
just, store the device or
to exchange an access-
ory part.
Handle the device with
•
care and keep it clean.
Store the device out of
•
reach of children.
Preparation
WARNING! Risk of injury due to
unintentional start-up. Do not in-
sert the plug into the outlet until the
device is fully prepared for use.
Control elements
Familiarise yourself with the operating
elements before using the device for
the first time.
On/Off switch (1)
• Switching on: Move the On/Off
switch (1) to the position "I" (ON).
• Switching off: Move the On/Off
switch (1) to the position "0" (OFF).
Filter cleaning button (6)
• Filter cleaning button, p. 31
Air control (21)
• Open the air control: Suction
power at the nozzle is lower.
Lock (16)
Adjust the length of the telescopic
suction tube (18).
1. Press and hold the lock (16) of the
suction tube (18) forwards.
2. Adjust the inner part of the tele-
scopic suction tube (18) to the de-
sired length.
3. Release the lock (16) of the suction
tube (18).
4. If the inner part of the telescopic
suction tube (18) does not engage,
push it forwards or backwards to
the next notch.
Attaching and removing the
motor head
Disassembling the motor head
(Fig. A)
1. Unlock the snap locks (9) on the
dirt container (10).
2. Take the motor head (3) off.
Place the motor head (3) with the
top facing downward.
Assembling the motor head (Fig. A)
1. Place the motor head (3) on the
direct container (10). The On/Off
switch (1) points to the suction
connector (14).
2. Lock the snap locks (9) on the dirt
container (10).
Assembly
State on delivery
• Motor head (pre-assembled)
• Pleated filter (pre-assembled)
• 5 × Foot (with castor and ac-
cessories holder) (not assembled).
Assembling the feet (Fig. B)
1. Remove the motor head (3).
GB
MT
27
