Parkside PWD 25 C4 Vertaling Van De Originele Gebruiksaanwijzing pagina 28
Beschikbare talen
Beschikbare talen
GB
MT
2. Place the dirt container (10) on a
solid surface with the bottom fa-
cing up.
3. Place the feet (11) in the holders
on the bottom of the dirt container.
You will hear the feet click into
place.
4. Mount the motor head (3).
Attaching and removing the
suction hose
Suction hose assembly (Fig. A)
1. Insert the thick end of the suction
hose (19) with the lock (20) into a
connector:
• Suction: Suction connector (14)
(on the dirt container)
• Blowing: Blower connector (15)
(on the motor head)
You will hear the lock click into
place.
Attaching the suction hose (Fig. A)
1. Press and hold the lock (20) on the
suction hose (19).
2. Pull the suction hose (19) out of
the connector.
Attaching and removing the
filter and filter bag
Overview
The appliance has the following filters
and bags:
• Pleated filter (25)
• Dry vacuuming
• Use an additional paper filter
bag so that the pleated filter
does not clog up so quickly.
• Filter cleaning button, p. 31
• Foam filter (23)
• Wet vacuuming
• Paper filter bag (26)
• Dry vacuuming
• Fine dust filter bag
• Vacuuming fine dust
28
• available as accessories
Disassembling the pleated filter
(Fig. C)
1. Remove the motor head (3).
Place the motor head (3) with the
top facing downward.
2. Unlock the lock (24) of the pleated
filter (25).
3. Remove the pleated filter (25).
Assembling the pleated filter
(Fig. C)
1. Remove the motor head (3).
Place the motor head (3) with the
top facing downward.
2. If necessary, remove the foam filter
(23).
3. Place the pleated filter (25) over
the filter basket (30).
4. If the pleated filter (25) is not im-
mediately in place, turn the lock
until the pleated filter moves with
the direction of the motor head (3).
5. Lock the lock (24) of the pleated
filter (25).
6. Mount the motor head.
Installing the filter bag (Fig. D)
These instructions apply for the paper
filter bag (26) and the fine dust filter
bag (available as accessories).
1. Remove the motor head (3).
Place the motor head (3) with the
top facing downward.
2. Inside the dirt container (10), pull
the filter bag over the suction con-
nector (14). The sealing ring on the
filter bag opening must fully sur-
round the connector on the suc-
tion connector.
3. Mount the motor head.
Removing the filter bag (Fig. D)
1. Remove the motor head (3).
Place the motor head (3) with the
top facing downward.
2. You can remove the filter bag.
