Pulox Checkme Lite Gebruiksaanwijzing pagina 125
IEC 61000-4-5
Voltage dips, short
Interruptions and
Voltage variations on
power supply input
lines
IEC 61000-4-11
Power frequency
(50/60 HZ) magnetic
field IEC 61000-4-8
Note: U
is the AC mains voltage prior to application of the test level.
T
Guidance and Declaration - Electromagnetic Immunity
The Health Monitor is intended for use in the specified electromagnetic environment. The
customer or the user of the Health Monitor should assure that it is used in such an environment
as described below.
Immunity
IEC60601
test
test level
Conduced
3 Vrms 150
RF
kHz to
IEC61000-
80 MHz
4-6
outside ISM
bands
Radiated
3 V/m 80
RF
MHz to 2.5
IEC61000-
GHz
4-3
Note 1: At 80 MHz to 800 MHz, the separation distance for the higher frequency range applies.
line(s)
± 2 kV line(s) to
earth
<5 % UT
(>95 % dip in UT)
for 0.5 cycle
40 % UT
(60 % dip in UT)
for 5 cycles
70 % UT
(30 % dip in UT)
for 25 cycles
<5 % UT
(>95 % dip in UT)
for 5 s
3 A/m
Compliance
level
3 Vrms 150 kHz
to
80 MHz
outside ISM
bands
3 V/m 80 MHz
to 2.5 GHz
line(s)
± 2 kV line(s) to
earth
<5 % UT
(>95 % dip in UT)
for 0.5 cycle
40 % UT
(60 % dip in UT)
for 5 cycles
70 % UT
(30 % dip in UT)
for 25 cycles
<5 % UT
(>95 % dip in UT)
for 5 s
3 A/m
Electromagnetic environment - guidance
Portable and mobile RF communications equipment
should be used no closer to any part of the system,
including cables, than the recommended separation
distance calculated from the equation appropriate
for the frequency of the transmitter. Recommended
separation distances:
Recommended separation distances:
80 MHz～800 MHz:
800MHz-2.5GHz:
d
Where, P is the maximum output power rating of
the transmitter in watts (W) according to the
transmitter manufacturer and d is the
recommended separation distance in meters (m).
Field strengths from fixed RF transmitters, as
determined by an electromagnetic site survey
should be less than the compliance level in each
frequency range
b
. Interference may occur in the
vicinity of equipment marked with the following
symbol:
124
Mains power quality should be
that of a typical commercial or
hospital environment. If the user
of our product requires
continued operation during
power mains interruptions, it is
recommended that our product
be powered from an
uninterruptible power supply or
a battery.
Power frequency magnetic fields
should be at levels characteristic
of a typical location in a typical
commercial or hospital
environment.
=
d
1
.
2
P
=
d
1
.
2
P
=
2
.
3
P
SE
a
,
