Pulox Checkme Lite Gebruiksaanwijzing pagina 30
6. Maintenance
6.1 Battery
This monitor has a rechargeable lithium-ion battery. The battery is
automatically charged when the monitor is connected to AC power or to
devices that can deliver power via a USB port.
The screen displays the respective battery status as follows:
When the colored part moves from left to right, the battery is being
charged.
Indicates that the battery is almost completely used up and should be
recharged immediately. Otherwise, the device will switch off automatically.
To charge the battery, connect the USB cable as
shown.
The device cannot be used for measurements
during charging.
Use USB chargers that are compatible with electricity safety standards, such
as IEC 60950.
6.2 Maintenance and cleaning
Clean the device by wiping it with a soft cloth soaked in water or alcohol.
6.3 Troubleshooting
Problem
The device does not
switch on
The ECG curve is
small.
The ECG curve
stops.
SpO2 or pulse value
is not displayed or
the value fluctuates
"Error XX" has
occurred
SpO2 value is too
low during
measurements with
Possible cause
1. The battery may be flat.
2. The device may be
damaged.
The applied lead is not
suitable for you.
1. The pressure applied to
the electrode is not stable
or is too strong.
2. Hand or body is moved.
1. The finger may not be
inserted correctly.
2. Finger or hand may be
moved.
Software or hardware error Restart the device. If the error still
1. The pressure on the
finger is too strong.
2. The finger may not be
Solution
1. Charge the battery and try again.
2. Please contact your distributor.
Select another lead and try again.
1. Do not hold the device too
loosely, but do not press too hard.
2. Try to remain still and try again.
1. Remove the finger and insert it
again. Observe the corresponding
notes when doing so.
2. Try to remain still and try again.
occurs, contact your distributor.
1. Insert the finger again - not too
loosely, not too tightly.
2. Make sure that the finger is in
29
EN
