Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
4. Press the button (9) START/PAUSE
The washing program will resume.
INFORMATION!
If you add a considerable amount of laundry during the wash, the laundry could be washed less
effectively, since the washing machine initially sensed a lower weight of the load of laundry and
added a smaller amount of water. Insufficient amount of water relative to the amount of laundry
could also cause damage to the laundry (rubbing of dry laundry), and washing time can be longer.
INFORMATION!
Washing time will resume from the point at which the washing programme was interrupted.
Errors
In case of an error or fault, the programme will be interrupted.
An acoustic signal will warn about such occurrence (see TROUBLESHOOTING AND ERROR TABLE),
and the error will be indicated on the display unit (E:XX).
Power supply failure
In case of a power supply failure, the washing programme is interrupted. When power supply is
restored, the washing programme is resumed from the point at which it was interrupted. Upon
completion of the washing cycle,
a power supply failure and on the effect on the execution of the washing programme.
Washing time will resume from the point at which the washing programme was interrupted.
Opening the door (pause/cancel/change programme)
Washing machine door can be opened, if the water level in the machine is low enough and if the water
temperature is not excessively high.
INFORMATION!
If the washing machine is not connected to the power mains or in case of a power supply failure
during the programme execution, then the washing machine door cannot be opened. In such
case, the washing machine has to be properly connected, or a service technician should be
contacted.
Displaying the number of completed wash cycles
(depending on the model)
If you disconnect the appliance from the power supply, wait for 10 seconds, and then reconnect the
power cord, information on the number of completed wash cycles is displayed on the display unit for
3 seconds. After 3 seconds, the appliance switches to standby mode.
50
/
will alternate on the display unit. This informs the user about
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
