Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Problem/
Indication on the display unit
Error
and problem description
Water heating error
Water draining error
Excessive amount of
detergent
Water leak detected in the
washing machine area
Water level sensor error
Water overflow
Excessive amount of
detergent
56
What to do?
Then, press the (9) START/PAUSE button to
resume the programme.
If the error reoccurs, call a service technician.
Restart the program; if the error reoccurs, call
a service technician.
Check the following:
•
is the pump filter clean,
•
is the drain hose clogged,
•
is the drain clogged,
•
if the discharge hose placed is placed
below the maximum and above the
minimum height (see chapter
»INSTALLATION AND CONNECTION/
Connecting and securing the water
discharge hose«);
press the (9) START/PAUSE button again.
If the error reoccurs, call a service technician.
Too much detergent may cause excessive
foaming in the drum. See description for
Turn off the washing machine and turn it back
on.
Inspect the exterior of the appliance. If you do
not observe any leaks, you can continue to
use the washing machine.
Unplug the power cord from the outlet; then,
plug the power cord back into the outlet and
switch on the washing machine.
Vent the appliance. Do this by draining and
cleaning the washing machine filter and
cleaning the wall-mounted trap.
If the error reoccurs, call a service technician.
If there is water in the drum that exceeds a
certain level, and an error is reported on the
display unit, the washing program will be
interrupted and water will be pumped out of
the washing machine.
Restart the program; if the error reoccurs, call
a service technician.
If there is water in the drum that exceeds a
certain level, and an error is reported on the
display unit, while the washing machine
continues to add water, close the water tap
and call a service technician.
Too much detergent may cause excessive
foaming in the drum. See description for
.
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
