Parkside PHKSA 20-Li C4 Vertaling Van De Originele Gebruiksaanwijzing pagina 30
Beschikbare talen
Beschikbare talen
GB
MT
risk of electric shock if your body
is earthed or grounded.
c) Do not expose power tools to
rain or wet conditions. Water en-
tering a power tool will increase
the risk of electric shock.
d) Do not abuse the cord. Never
use the cord for carrying, pulling
or unplugging the power tool.
Keep cord away from heat, oil,
sharp edges or moving parts.
Damaged or entangled cords in-
crease the risk of electric shock.
e) When operating a power tool
outdoors, use an extension cord
suitable for outdoor use. Use of
a cord suitable for outdoor use re-
duces the risk of electric shock.
f) If operating a power tool in a
damp location is unavoidable,
use a residual current device
(RCD) protected supply. Use of
an RCD reduces the risk of electric
shock.
3. PERSONAL SAFETY
a) Stay alert, watch what you are
doing and use common sense
when operating a power tool. Do
not use a power tool while you
are tired or under the influence
of drugs, alcohol or medication.
A moment of inattention while op-
erating power tools may result in
serious personal injury.
b) Use personal protective equip-
ment. Always wear eye protec-
tion. Protective equipment such
as a dust mask, non-skid safety
shoes, hard hat or hearing protec-
tion used for appropriate condi-
tions will reduce personal injuries.
c) Prevent unintentional starting.
Ensure the switch is in the off-
position before connecting to
power source and/or battery
pack, picking up or carrying the
30
tool. Carrying power tools with
your finger on the switch or ener-
gising power tools that have the
switch on invites accidents.
d) Remove any adjusting key or
wrench before turning the power
tool on. A wrench or a key left at-
tached to a rotating part of the
power tool may result in personal
injury.
e) Do not overreach. Keep proper
footing and balance at all times.
This enables better control of the
power tool in unexpected situ-
ations.
f) Dress properly. Do not wear
loose clothing or jewellery. Keep
your hair and clothing away from
moving parts. Loose clothes, jew-
ellery or long hair can be caught in
moving parts.
g) If devices are provided for the
connection of dust extraction
and collection facilities, ensure
these are connected and prop-
erly used. Use of dust collection
can reduce dust-related hazards.
h) Do not let familiarity gained from
frequent use of tools allow you
to become complacent and ig-
nore tool safety principles. A
careless action can cause severe
injury within a fraction of a second.
4. POWER TOOL USE AND CARE
a) Do not force the power tool. Use
the correct power tool for your
application. The correct power
tool will do the job better and safer
at the rate for which it was de-
signed.
b) Do not use the power tool if the
switch does not turn it on and
off. Any power tool that cannot be
controlled with the switch is dan-
gerous and must be repaired.
