Parkside PHKSA 20-Li C4 Vertaling Van De Originele Gebruiksaanwijzing pagina 34
Beschikbare talen
Beschikbare talen
GB
MT
Additional safety instructions
• Make sure the tips of the saw
teeth do not overheat.
• When sawing plastic, make sure
the plastic does not melt.
• Pay attention to the maximum
cutting depth. (see technical
data)
• When sawing, wear a dust mask.
• Always wear hearing protection!
• Only use accessories recom-
mended by PARKSIDE. Unsuit-
able accessories may cause elec-
tric shock or fire.
Residual risks
There will always be residual risks
even if you operate this device ac-
cording to the instructions. The fol-
lowing hazards may occur in connec-
tion with the type and design of this
device:
• Eye damage if no suitable eye pro-
tection is worn.
• Hearing damage if suitable ear pro-
tection is not worn.
• Health injuries resulting from the
effect of hand/arm vibration in the
event that the tool is used over a
longer period of time or is not used
and maintained properly.
• Cutting injuries
WARNING! Danger due to elec-
tromagnetic field generated while the
tool is in operation. Under certain cir-
cumstances, this field may negat-
ively affect active or passive med-
ical implants. In order to reduce the
danger of serious or fatal injuries, we
recommend that individuals who wear
medical implants should consult their
doctor and the manufacturer of the
implant before operating the tool.
34
Preparation
WARNING! Risk of injury due to
unintentional start-up. Only insert
the battery into the device once the
device is fully prepared for use.
Control elements
Familiarise yourself with the operating
elements before using the device for
the first time.
• Switch lock (1)
• Locks the on/off switch against
unintentional operation.
• Unlocking: Press
• On/Off switch (2)
• Switching on: Press
• Switching off: Release
• Guide notch (34)
• Helps to guide the tool straight.
• Only available for the following
cutting angles: 0°, 45°
Attaching and removing the
saw blade
CAUTION! Risk of injury
when touching the saw blade.
Wear protective gloves when
handling the saw blade.
Requirements
• Never use a grinding disc. The
speed and safety devices of a
circular saw are not suitable for
grinding discs.
• Select a suitable saw blade ac-
cording to the material to be sawn.
• Saw blades intended for cutting
wood or similar materials must
comply with EN 847-1.
• Only use saw blades with diamet-
ers corresponding to the labelling
on the saw.
• Only use saw blades with a max-
imum diameter: 160 mm
