Parkside PHKSA 20-Li C4 Vertaling Van De Originele Gebruiksaanwijzing pagina 37
Beschikbare talen
Beschikbare talen
• Do not expose the battery to dir-
ect sunlight for long periods and
do not place it on a radiator (max.
50°C).
Charging the battery
1. Remove the battery (29) from the
device.
2. Push the battery (29) into the char-
ging slot of the battery charger
(27).
3. Connect the battery charger (27) to
a power outlet.
4. After charging, disconnect the bat-
tery charger (27) from the mains.
5. Pull the battery (29) out of the bat-
tery charger (27).
Control LEDs on the charger
Meaning of the control indicators on
the charger (27):
green
red
lights up
—
lights up Battery is char-
—
flashes Battery not re-
flashes
Operation
Information on sawing
• The maximum speed stated on the
tool must not be exceeded. If in-
dicated, the speed range must be
complied with.
• Maintenance work and modifica-
tions to circular saw blades should
only be performed by a profes-
sional, i.e. a person with specialist
training and experience who is fa-
miliar with the design requirements
and the necessary safety steps.
Meaning
• Battery is fully
charged
• stand-by (No
battery inser-
ted)
ging
cognized
Inserting and removing the
battery
WARNING! Risk of injury due to
unintentional start-up. Only insert
the battery into the device once the
device is fully prepared for use.
NOTICE! Risk of damage! An incor-
rect battery can damage the device
and battery.
Inserting the battery
1. Push the battery (29) along the
guide into the battery holder (19).
You will hear the battery click into
place.
Removing the battery
1. Press and hold the battery release
(28) on the battery (29).
2. Pull the battery out of the battery
holder (19).
Switching on and off
Switching on
1. Insert the rechargeable battery (29)
into the device.
2. Press and hold the switch lock (1).
3. Press and hold the On/off switch
(2).
4. Wait until the device has reached
full speed.
Switching off
1. To turn it off, release the on/off
switch (2).
2. Do not pull the sawblade out
of the cut until it has come to a
standstill.
3. Remove the rechargeable bat-
tery (29) from the device if you are
leaving the device unattended or if
you have finished working.
Transport
Notes
• Turn off the device.
GB
MT
37
