Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
6.4-
Connecting the 'supply' charge/discharge line (black
socket no.4) in case of "dedicated line" installation. See
paragraph 6.2
• Use the specific equipment meant for this
• Only connect devices which require a supply voltage of
12VCC and pay attention to polarity
• When connecting a 230/12V charger, check the voltage
(14.6V MAX) and load curve of the charger before connection.
Position the charger in Lithium or Gel mode. Otherwise, refer to
the recommendations.
1
2
3
4
1/ Get the connection cable for
EZA output
CABLE MUST BE ORDERED – NOT
INCLUDED
2/ Get the cables from the
original service battery back
and attach the adapted lugs to
the section of cable.
3/
Connect
the
cables to the fuse holder paying
attention to polarity using lugs
and nuts. Fold the fuse holder
back shut.
4/ Connect the kit to the EZA
power pack with the black
connector.
Please respect the maximum
authorised power and voltage
for this charge/discharge line:
70A and 12V
attached
49
Advertenties
Hoofdstukken
Inhoudsopgave
