Inhoudsopgave
Advertenties
EN
1
SCOPE OF APPLICATION
e
LT is a battery-powered sprayer that ensures OPTIMAL AND SAFE SPRAYING for your vegetables or garden [1.a].
Enables to easily select the most suitable work mode for each type of application.
To achieve this equipment is sized with a pump
and a battery, which enables the alternation
between the 2 standard nozzles to adjust the
spray pattern.
Adjustable
conical
insecticide and fungicide treatments, in which
fine drops with good coverage are required,
and a low-drift nozzle, suitable for herbicide
treatments with thicker drops, in order to avoid
drift.
The GOIZPER ACCESSORIES enables the operator to tailor the equipment to each type of treatment [1.b]. For more
information, see www.matabi.com.
This sprayer has been designed so as to apply phytosantiary products (fungicides, herbicides and insecticides)
approved by the authorities which regulate these types of products for use with sprayers [1.a]. Under no
circumstances whatsoever should the apparatus be used for spraying flammable and industrial products (solvents,
acids, alkalis, etc.).
It is important that this manual is read and understood prior to starting to use the equipment.
Pay special attention to equipment cleaning and maintenance tips so as to ensure an extended
service life of the sprayer.
Similarly pay special attention to safety regulations. Failure to follow the instructions and
safety warnings may result in serious injury.
followed may create the issues as described below.
ASSEMBLY AND START UP
2
•
ASSEMBLY: For assembly follow the instructions given in the photos in Section [2.a].
VERIFICATION: Verify with water that the equipment has been assembled correctly, that it is not damaged and
•
is in good working condition.
START-UP: For starting up follow the instructions given in the photos in Section [2.b].
•
•
BATTERY: Before each working day, ensure that the battery is charged. To charge the battery, see Section 6. Battery.
When installing the battery in the equipment, ensure that it is securely locked. [2.7]
•
CHEMICAL PRODUCT: For difficult to dilute products, it is recommended to prepare the mixture beforehand in
a separate container.
•
WORKING POSITION SELECTION: Select the nozzle for your application according to Tables T.1 and T.2. [2.9]
EQUIPMENT PERFORMANCE MAY BE REDUCED IF A NOZZLE IS USED WHICH
HAS NOT BEEN RECOMMENDED IN TABLES T.1 AND T.2.
•
TURNING THE EQUIPMENT OFF: The equipment is fitted with a pressure switch which stops the motor when
the handle is released, but the equipment is still turned on. To completely turn the equipment off, set the switch
to the OFF position according to the photo [2.11].
TO EXTEND THE EQUIPMENT'S SERVICE LIFE, AT THE END OF THE WORKING DAY, TURN
THE MAIN SWITCH OFF, ACTIVATE THE HANDLE TO RELEASE THE PRESSURE FROM THE
HYDRAULIC CIRCUIT [2.11] AND REMOVE THE BATTERY FROM THE EQUIPMENT.
12 /
nozzle,
suitable
for
LD
-
This symbol helps to identify such recommendations.
The following symbol helps the operator to recognise the situations which when not
HERBICIDE APPLICATION
Medium droplet size
LD
Low Drift
Low Drift
-
Precision and minimal drift
Droplet size: VC: Very thick; C: thick; M: medium; F: fine
INSECTICIDE + FUNGICIDE APPLICATION
Fine droplet size
HC
HC
Hollow Cone
Hollow Cone
-
-
Adjustable
Advertenties
Inhoudsopgave
