Parkside PBS 350 C3 Vertaling Van De Originele Gebruiksaanwijzing pagina 12
Beschikbare talen
Beschikbare talen
• When cutting round or irregular shaped wood, use
a device to secure the workpiece and prevent it
turning.
• When cutting boards on edge, use a device to pre-
vent the workpiece kicking back.
• If devices are provided for the connection of
dust extraction and collection facilities, ensure
these are connected and properly used. Use of
dust extraction can reduce dust-related hazards.
• The product may only be operated by people who
are familiar with handling it.
WARNING
The supplied band saw blade is only intended for the
sawing of wood! Do not use this blade for sawing
firewood!
• Before commissioning, ensure that the mains volt-
age matches with the operating voltage on the type
plate.
• Long supply cables, extensions, cable reels, etc.
cause a drop in voltage and can impede motor
start-up.
• Keep children and other people away while using
the product. Distractions may cause you to lose
control of the product.
• Observe the direction of rotation of the motor and
saw band.
• Never operate the product with defective Protec-
tive devices or without safety devices.
• Do not process workpieces that are too small in or-
der to keep them secure in your hands.
WARNING
Danger of injury!
If you remove blockages with your bare hands, you
may injure yourself.
–
Wear protective gloves.
–
Use suitable tools (e.g. a wooden stick).
• Set the adjustable guards such that they are as
close as possible to the workpiece.
• Protective covers must not be used for transport or
improper operation of the product.
WARNING
Do not use damaged or deformed tool attachments.
WARNING
Make sure that the tool attachment is suitable for the
material to be processed.
6
|
GB / IE / NI / CY / MT
WARNING
With a damaged table inlay there is a risk of small
parts jamming between table inlay and saw blade,
blocking the saw blade.
Immediately replace damaged table inlays!
WARNING
There is a risk of accident! Always carry out
cleaning
work
when
switched off. There is a danger of injury!
Let the product cool down before cleaning.
Elements of the engine are hot. There is a
danger of injury and burning!
The product can start unexpectedly and cause inju-
ries.
–
Switch off the product before all cleaning work.
–
Allow the engine to cool down.
ATTENTION
The teeth of the band saw blade must point down-
wards.
• Do not use the product if it is damaged. Never re-
move protective devices from the product. This can
result in serious injuries.
• For mitre cuts with an inclined saw table, the paral-
lel stop should be placed on the lower part of the
saw table.
ATTENTION
Secure long workpieces against tipping at the end of
the cutting process (e.g. with a roller stand or simi-
lar).
• Keep your hands at a safe distance from the band
saw blade. Use a push stick for narrow cuts.
• Store the push stick on the holder provided for it on
the product so that you can reach it from your nor-
mal working position and always have it to hand.
• Switch the product off if it is not in use.
• In the normal working position, the operator is in
front of the product.
Residual risks
The product has been built according to state-of-
the-art and the recognised technical safety rules.
However, individual residual risks can arise during
operation.
• Residual risks can be minimised if the "Safety In-
structions" and the "Intended Use" together with
the operating manual as a whole are observed.
the
product
is
