Parkside PBS 350 C3 Vertaling Van De Originele Gebruiksaanwijzing pagina 23
Beschikbare talen
Beschikbare talen
18 Troubleshooting
Fault
Motor does not work
The engine runs slowly and
does not reach the operating
speed.
Engine producing excessive
noise.
The engine does not reach full
power.
Motor overheats easily.
Saw cut is rough or wavy.
Workpiece pulls away and/or
splinters.
Band saw blade drifting.
Burn marks on the wood when
working.
Band saw blade jams when
working.
Motor runs but saw blade does
not move
Possible cause
Motor, cable or plug defec-
tive, mains fuses blown,
both safety switches are not
correctly engaged.
Voltage too low, coils dam-
aged, capacitor burnt.
Coils damaged, motor de-
fective.
Circuits in the network are
overloaded
(lamps,
other
motors, etc.).
Overloading of the motor,
insufficient cooling of the
motor.
Band saw blade dull, tooth
shape not appropriate for
the material thickness.
Excessive cutting pressure
and/or band saw blade not
suitable for use.
• Band saw blade guide
poorly adjusted.
• Incorrect
band
saw
blade.
• Band saw blade blunt.
• Incorrect
band
saw
blade.
• Band saw blade blunt.
• Band saw blade resin-
ous.
• Band saw blade guide
poorly adjusted.
Belt is not
correctly tensioned
Remedy
Arrange for inspection of the product by a specialist.
Never repair the motor yourself. Danger! Check
mains fuses, replace if necessary, engage both safe-
ty switches correctly
Have an electrician check the voltage. Arrange for
inspection of the motor by a specialist. Arrange for
replacement of the capacitor by a specialist.
Arrange for inspection of the motor by a specialist.
Do not use any other products or motors on the
same circuit.
Avoid overloading the motor while cutting, remove
dust from the motor in order to ensure optimal cool-
ing of the motor.
Resharpen band saw blade or insert suitable band
saw blade.
Insert suitable band saw blade.
• Adjust the band saw blade guide.
• Insert suitable band saw blade.
• Replace the band saw blade.
• Insert suitable band saw blade.
• Replace the band saw blade.
• Clean the band saw blade.
• Adjust the band saw blade guide.
Retighten belt
GB / IE / NI / CY / MT
|
17
