Dimplex Aspire ASP30-EU Installatie- En Gebruikershandleiding pagina 11
Installation
4
Install power cord
WARNING: The installation of the electric fireplace must comply with the applicable Local and/or National
Electrical Codes and utility requirements.
Use the appropriate cord to meet local and national electrical codes for rated power consumption.
CAUTION: A dedicated, properly fused 13 Amp circuit is required, rated for the appropriate voltage (230-
240V). An isolation switch should also be incorporated in cases where the product plug is inaccessible after
installation.
WARNING: This heater is not intended for use with an extension cord. Plug the cord directly into an appropriate
grounded wall receptacle.
NOTE: The fireplace is supplied with the power switch
in the OFF position. It is located in the lower right side.
Two power cords are provided (EU or UK option)
with the fireplace.
Install the suitable power cord if the incorrect set
came installed on the unit.
EU
UK
11
