c When battery pack is not in use, keep it away
from other metal objects, like paper clips,
coins, keys, nails, screws or other small metal
objects, that can make a connection from one
terminal to another. Shorting the battery termi-
nals together may cause burns or a fire.
d Under abusive conditions, liquid may be
ejected from the battery; avoid contact. If con-
tact accidentally occurs, flush with water. If
liquid contacts eyes, additionally seek medi-
cal help. Liquid ejected from the battery may
cause irritation or burns.
e Do not use a battery pack or tool that is dam-
aged or modified. Damaged or modified batter-
ies may exhibit unpredictable behaviour resulting
in fire, explosion or risk of injury.
f Do not expose a battery pack or tool to fire or
excessive temperature. Exposure to fire or tem-
perature above 130 °C may cause explosion.
g Follow all charging instructions and do not
charge the battery pack or tool outside the
temperature range specified in the instruc-
tions. Charging improperly or at temperatures
outside the specified range may damage the bat-
tery and increase the risk of fire.
Safety Instructions for Installation
● Do not install the charging station, including any
accessory, at a location that is below, or within
50 cm. from, any combustible material. In case
of malfunction, heating of the charging station
and the power supply mayoccur and create a po-
tential risk of fire.
● Do not put the power supply at a height where
there is a risk it can be put in water. Do not put
the power supply on the ground.
● Do not encapsulate the power supply. Con-
densed water can harm the power supply and in-
crease the risk ofelectrical shock.
● Do not install the charging station where there is
a risk of standing water.
Safety Instructions for Daily Operation
● Keep your hands and feet away from the rotating
blades. Do not put your hands or feet near or be-
low the product when it is set to ON.
● Use the park mode or set the product to OFF
when persons, especially children or animals
are in the work area.
● Make sure that there are no objects such as
stones, branches, tools or toys on the lawn. The
blades can be damaged if it hits an object.
● Do not lift the product or move it when it is set to
ON.
● Do not to let the product collide with persons or
animals. lf a person or animal comes in the way
of the product, stop the product immediately.
● Do not put objects on top of the product, the
charging station or the RTK reference station.
● Do not use the product if the STOP button does
not work.
● Always set the product to OFF when it is not in
operation.
● Do not use the product at the same time as a
pop-up sprinkler. Use the Schedule function so
the product and pop-up sprinkler do not operate
at the same time.
● Do not let the product operate when there is
standing water in the work area. For example,
when heavy rain forms pools of water.
● Do not expose the device to high pressure wa-
ter.
Safety of Persons and Animals
● In areas accessible to the public, affix warning
information with the following content around
the mowing area:
ATTENTION
operation! Do not approach the appliance! Su-
pervise children.
Only use the appliance under the following condi-
tions:
● The appliance is not soiled.
● The appliance shows no damage or wear.
● The charging station and power supply as well as
their electrical supply cables are undamaged and
function properly.
Note
● This device has been tested and found to comply
with the limits for a class B digital device, pursuant
to part 15 of the FCC rules.
● These limit values are designed to provide adequate
protection against harmful interference in residential
areas.
● This equipment generates, uses and can radiate ra-
dio frequency electricity. If it is not installed and
used in accordance with the instructions, this can
cause harmful interference to radio communica-
tions.
● However, there is no guarantee that interference will
not occur in a particular application.
● If the device causes interference to radio or televi-
sion reception, which can be determined by turning
the device off and on, we recommend that you elim-
inate the interference by one or more of the follow-
ing measures:
–
Change the orientation or location of the receiv-
ing antenna.
–
Increase the separation between the device and
the receiver.
–
Connect the device to a power socket on a circuit
different from that to which the receiver is con-
nected.
–
Contact a dealer or an experienced radio / televi-
sion technician.
● The device must not be set up or operated together
with another receiving antenna or another transmitter.
● To comply with FCC regulations, the device must be
installed at a minimum distance of 20 cm from people in
the vicinity. ● This device complies with Part 15 of the
FCC Rules and Industry of Canada licence-exempt
RSS standard(s). Operation is subject to the following
two conditions:
1
This device must not cause harmful interference,
and
2
This device must accept any interference received,
including interference that may cause undesired op-
eration.
Note Changes or modifications to this equipment not
expressly approved by Kärcher could void the FCC au-
thorisation to operate this equipment.
English
● Automatic lawn mower in
FCC rules
17