Dometic CRUISE CONTROL MS880 Handleiding pagina 3
Verberg thumbnails
Zie ook voor CRUISE CONTROL MS880:
- Montagehandleiding en gebruiksaanwijzing (292 pagina's)
Beschikbare talen
Beschikbare talen
All manuals and user guides at all-guides.com
MS880
Contents
1
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
2
Recording travel speed signals/engine speed signals . . . . . . . . . . . . . . . . . .7
2.1
Recording travel speed signals . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
2.2
Recording engine speed signals . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
2.3
Testing the signal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
3
Setting the sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
3.1
Starting setup mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
3.2
Starting automatic mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
3.3
Setting the sensitivity (INIT mode) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
3.4
Setting the control sensitivity manually (GAIN mode). . . . . . . . . . . . . . . . . . 11
3.5
Quitting setup mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
1
Troubleshooting
This section contains a list of possible problems and recommended tests you can
perform to find a solution.
The LED on the electronic module does not light up when you press the
buttons on the control element
➤ Check that the 8-pin compact plug of the electronic module is properly
connected to the control element.
➤ Check the colour code on the connecting plug of the control element and make
sure that the terminals are correctly plugged into the control element.
➤ If the plugs are correctly inserted, check the power supply and earth connection
of the electronic module.
There should be a voltage of +12 V on the orange cable when the ignition is
switched on.
The green cable should have a good earth connection.
EN
Troubleshooting
3
