Dometic CRUISE CONTROL MS880 Handleiding pagina 6

Verberg thumbnails Zie ook voor CRUISE CONTROL MS880:

Beschikbare talen

All manuals and user guides at all-guides.com

Troubleshooting

The electronic module does not change the engine speed in diagnosis

mode B

➤ Perform all the other diagnosis mode tests again to make sure that the problem is

not caused by the electrical connections or by the control element.

➤ Switch the ignition off.

➤ Quit diagnosis mode.

➤ Leave the ignition switched off for several seconds.

➤ Press the SET button again and hold it down.

➤ Start the vehicle again to start diagnosis mode.

➤ Repeat diagnosis mode B again.

➤ Make sure the starter is not working.

➤ Check the plug connection to the electronic module, make sure the cables are

correctly positioned and pay attention to the colour code of the plug.

➤ Use a voltmeter to test that none of the cables in the wiring harness are damaged.

The cruise control does not work evenly in control mode

➤ If the cruise control reacts too suddenly or the vehicle speeds up too much in

control mode, you must decrease the GAIN value (see chapter "Setting the con-

trol sensitivity manually (GAIN mode)" on page 11).

➤ If the cruise control operates too slowly in control mode, you must increase the

GAIN value (see chapter "Setting the control sensitivity manually (GAIN mode)"

on page 11).

MS880