Dometic CRUISE CONTROL MS880 Handleiding pagina 9
Verberg thumbnails
Zie ook voor CRUISE CONTROL MS880:
- Montagehandleiding en gebruiksaanwijzing (292 pagina's)
Beschikbare talen
Beschikbare talen
All manuals and user guides at all-guides.com
MS880
To start setup mode, proceed as follows:
➤ Depending on the mode, do one of the following:
– For automatic mode: start the motor.
– For the other modes: switch the ignition off and on again.
➤ Press the ON/OFF button on the control element.
➤ Apply the brake within one minute and hold it down.
➤ Press the setup button four times in rapid succession.
➤ Release the brake.
✓ You will hear four acoustic signals.
✓ You are now in setup mode and can set the cruise control.
3.2
Starting automatic mode
In automatic mode, the PPM and GAIN parameters are automatically synchronised
with your vehicle. You can still fine-tune both parameters anytime.
➤ Start setup mode (chapter "Starting setup mode" on page 8).
➤ Apply the brake and hold it down.
➤ Press the RES button twice.
✓ You will hear two low-pitched signals.
➤ Release the brake.
✓ You will hear two high-pitched signals.
I
NOTE
If you hear more than two signals, repeat the procedure.
➤ Drive the vehicle at a speed of 70 km/h to allow the PPM and GAIN parameters
to be set automatically.
➤ Press the SET button.
✓ The cruise control switches itself on.
EN
Setting the sensitivity
9
