Dometic CRUISE CONTROL MS880 Handleiding pagina 8
Verberg thumbnails
Zie ook voor CRUISE CONTROL MS880:
- Montagehandleiding en gebruiksaanwijzing (292 pagina's)
Beschikbare talen
Beschikbare talen
All manuals and user guides at all-guides.com
Setting the sensitivity
2.2
Recording engine speed signals
You can record the engine speed signal at the following positions:
Position
Engine speed signal transmitted via the engine
controller
Electronic speed sensor
(on the rear of the instrument assembly or as part set of
the instrument assembly)
Negative terminal end of the ignition coil (terminal 1)
(The yellow cable must be used for this type of
connection)
2.3
Testing the signal
Use a voltmeter to test the signal, proceeding as follows:
I
NOTE
Make sure all digital voltmeters measure the effective voltage when
operating in the AC range.
➤ Connect the red lead of the voltmeter to the selected speed signal.
➤ Connect the black lead of the voltmeter to the vehicle earth.
➤ Drive the vehicle at the activation speed of the cruise control (approx. 40 km/h).
➤ Measure the effective voltage of the signal.
3
Setting the sensitivity
3.1
Starting setup mode
I
NOTE
• To begin one of the adjusting and teach modes you must always
carry out the following procedure.
• For automatic mode (page 9), you first have to start the motor.
• For any of the other modes, you first simply have to switch the
ignition off and on again.
8
Voltage
Frequency
V
Hz
1,5 – 24
6 – 8500
1,5 – 24
6 – 488
6 – 250
6 – 488
MS880
EN
