PRIXTON RUN FIT RF150 Handleiding pagina 18
CARE, MAINTENANCE & TROUBLESHOOTING GUIDE
WARNING: To prevent electrical shock, please turn off and unplug the treadmill before
cleaning or performing routine maintenance.
WARNING: Always check the wear and tear components like spring knob and running belt to
prevent injury.
CLEANING
After each exercise, ensure that the unit is wiped down and any sweat is removed from
the unit.
The treadmill can be cleaned with a soft cloth and mild detergent. Do not use abrasives or
solvents. Be careful not to get excessive moisture on the display panel as this might damage
the unit and create an electrical hazard.
Please keep the treadmill, especially the computer console, out of direct sunlight to prevent
damage to the screen.
STORAGE
Store the treadmill in a clean and dry indoor environment. Never leave or use the unit
outdoors. Ensure the master power switch is off and the power cord is un-plugged from wall
outlet.
TROUBLESHOOTING GUIDE
Problem
Treadmill will not
start.
Belt slips
Belt hesitates
when stepped on.
Belt is not centred.
WARM UP AND COOL DOWN ROUTINE
The WARM-UP is an important part of any workout. The purpose of warming up is to
prepare your body for exercise and to minimize injuries. Warm up for two to five minutes
before aerobic exercising. It should begin every session to prepare your body for more
strenuous exercise by heating up and stretching your muscles, increasing your circulation
and pulse rate, and delivering more oxygen to your muscles.
COOL DOWN at the end of your workout, repeat these exercises to reduce soreness in
tired muscles. The purpose of cooling down is to return the body to its resting state at the
end of each exercise session. A proper cool-down slowly lowers your heart rate and allows
blood to return to the heart.
Potential Causes
1.Treadmill not plugged in.
2.Safety Tether Key is not
correctly installed.
3.Circuit breaker in the
house has been tripped.
4.Treadmill circuit breaker
has been tripped.
Belt not tight enough.
1.Not enough lubrication
applied onto the running deck.
2.Belt is too tight.
Running belt tension not even
across the rear roller.
1.Plug the power cord into a wall
outlet.
2.Reinstall the Safety Tether Key.
3.Reset the circuit breaker, or call
an electrician to replace the circuit
breaker.
4.Wait 5 minutes and then try to
restart the treadmill.
Adjust belt tension.
1.Apply lubricant.
2.Adjust belt tension.
Centre the belt.
18
Corrections
