Parkside PBKS 53 B3 Vertaling Van De Originele Gebruiksaanwijzing pagina 44
Beschikbare talen
Beschikbare talen
GB
MT
Adjusting the oil flow (Fig. B)
Turn the oil regulating screw (22) on
the underside using a slotted screw-
driver.
• ⭯ : Increase oil flow
• ⭮ : Decrease oil flow
Cleaning the oil passage (Fig. C)
Clean the oil passage regularly to en-
sure fault-free, automatic oiling of the
saw chain during operation.
1. Mounting the saw chain and blade
bar, p. 52
2. Remove any residues and dirt in
the oil passage (26) using a brush
or cloth.
3. If cleaning the oil passage is un-
successful, have the chainsaw re-
paired by our Customer Service.
contact the service centre.
Pouring in chain oil
WARNING! Risk of fire! Always
turn off the device and let the engine
cool down before filling with chain oil.
NOTICE! If the chainsaw is used with
too little oil, the cutting performance
and lifespan of the saw chain will de-
crease as the saw chain will become
blunt more quickly. You can recognise
insufficient oil by the smoke develop-
ment or discolouration of the blade
bar. Make sure that there is always
oil flowing onto the chain.
The oil flows to the blade bar (10) as
soon as the chain starts running.
• Check the oil level regularly and
top up with oil if the level is low.
Tank capacity: 260 cm
• Use bio chain oil containing addit-
ives to reduce friction and wear. Al-
ternatively, use chain lubricating oil
with a low proportion of adhesion
additives.
44
• Empty the oil tank if it will not be
Procedure (Fig. A)
1. Place the device on its side with
2. Unscrew the tank cover (8).
3. Pour the bio chain oil into the tank.
4. Wipe away any spilt oil.
5. Screw on the tank cover (8).
Mixing and filling fuel
Always ensure good ventilation when
handling fuel. Do not smoke while re-
fuelling and keep any heat sources
at a distance. Never refuel while the
engine is running. Carefully open the
fuel filler cap so that any overpressure
can slowly dissipate. Start the device
at a distance of at least 3 m from the
fuelling point.
ture recommended in the instructions.
The fuel mixture ages. Therefore, do
not use fuel mixtures that are older
than 3 months (E10: 30 days). If this
not done, the engine may become
damaged and your warranty will be-
come null and void.
Avoid direct skin contact with petrol
and inhalation of petrol fumes.
NOTICE! Unsuitable fuel can dam-
age the two-stroke engine. Only oper-
ate the device with a mixture of petrol
and two-stroke engine oil at a ratio of
40:1.
3
(0.26 l)
Petrol
40 parts
1 L
3 L
5 L
used for a prolonged period of time
(6–8 weeks).
the tank cover (8) facing upwards.
DANGER! Risk of fire or explosion!
CAUTION! Use only the fuel mix-
WARNING! Danger to health!
2-stroke oil
1 part
25 ml
75 ml
125 ml
