Parkside PBKS 53 B3 Vertaling Van De Originele Gebruiksaanwijzing pagina 56
Beschikbare talen
Beschikbare talen
GB
MT
8. Mount the blade bar (10), saw
chain (9) and sprocket cover (13)
and tighten the saw chain (9).
NOTICE! When in an optimal condi-
tion, the oil passages will automatic-
ally spray the saw chain with a little
oil a few seconds after starting the
chainsaw.
Changing the chain catch
1. Mounting the saw chain and blade
bar, p. 52
2. Loosen the screws on the chain
catch (11).
3. Replace the chain catch (11).
4. Tighten the screws on the chain
catch (11).
5. Installing the saw chain and blade
bar, p. 53
Turning the blade bar
CAUTION! Cutting injuries! Wear
cut-resistant gloves when working
with the saw chain or with the blade
bar.
Notes
• The blade bar (10) needs to be re-
versed regularly after a working
time of about 10 hours in order to
ensure even wear.
Procedure (Fig. C)
1. Mounting the saw chain and blade
bar, p. 52
2. Turn the blade bar along its hori-
zontal axis.
When doing so, pay attention to
the correct rotation direction of the
saw chain
3. Installing the saw chain and blade
bar, p. 53
Storage
• Clean the device prior to storage.
• Attach the encasing (16).
56
• The combination wrench (17) can
be stowed in the encasing (16) for
storage (Fig. A).
• Empty the oil tank prior to longer
periods of non-use. Dispose of
waste oil environmentally correctly
(Disposal/environmental protection,
p. 58).
There may still be oil residues
within hoses and in the device
that could leak out during stor-
age. Place the device on a suitable
base/oil pan for storage.
• Store the device in a dry and dust-
proof location and out of reach of
children.
Storage when not in operation
CAUTION! Fuel residues in the
carburettor can cause starting prob-
lems or permanent damage to the
device.
For operational breaks of up to 3
months
1. Drain the fuel tank in a well-ventil-
ated place.
2. Start the engine, allowing it to idle
until the engine stops and the car-
burettor is free of fuel.
3. Let the engine cool off (about 5
minutes).
Further actions for operational
breaks of more than 3 months
1. Remove the spark plug (33) with
the combination tool (17) (Check-
ing/adjusting/replacing spark plug,
p. 52).
2. Fill a teaspoon with pure two-
stroke oil into the combustion
chamber.
3. Pull the starter cable slowly sever-
al times to distribute the oil inside
the engine.
4. Put the spark plug (33) back in.
