VEVOR S7Y Handleiding pagina 11
Loopbandpad
Beschikbare talen
Beschikbare talen
roller to tighten the running belt.
2.
Repeat step 1 to adjust the screw on the right. Ensure that the regulating
screw is turned by the same distance to make the rear roller parallel with the
frame.
3.
Repeat step 1 and 2 until the running belt is not slip.
4.
Note: the running belt shall not be too tight, which will damage the running
belt, roller bearing, etc., increase pressure of front/rear roller, and bring
abnormal sound or other problems. To reduce tension of running belt, please
turn the wrench anticlockwise by same distance on both sides.
Adjust running belt to the middle
When you use the treadmill, the force of feet is different, and pressure on running
belt is unbalanced, which makes the running belt deviate from the center. Such
deviation is normal. It will return to the center when nobody is running on the
running belt. You need to adjust it to the center if it fails to return to the center.
1.
Keep the treadmill in no-load running and adjust speed to 3mph.
2.
Observe the distance from running belt to left and right edgestrips
•
If the running belt tilts towards the left, turn the left screw by 1/4 of a
circle clockwise with Allen wrench.
•
If the running belt tilts towards the right, turn the right screw by 1/4 of a
circle clockwise with Allen wrench.
•
If the running belt is still not in the middle, repeat the above steps until it
is in the middle.
4.
Warning! Please don't tighten the roller excessively! This will cause
permanent damage to the bearing!
You need to tighten the running belt again if the above steps fail to reach the effect.
11
