VEVOR S7Y Handleiding pagina 17

Loopbandpad

Beschikbare talen

This product is subject to the provision of european Directive 2012/19/EU.

The symbol showing a wheelie bin crossed through indicates that the

product requires separate refuse collection in the European Union. This

applies to the product and all accessories marked with this symbol. Products

marked as such may not be discarded with normal domestic waste, but must be

taken to acollection point for recycling electrical and electronic devices.

Fault Code Guidelines

This fault is a communication problem between the upper and lower air.

Troubleshooting :

Method 1. Check if the upper and lower air connection wires are not in good

contact. If they are not in good contact, please insert the wires into the

buckle to troubleshoot the problem.

Method 2.Check if the wires are twisted or broken in appearance. If this

phenomenon occurs, replace the connecting wires.

The fault is motor wire detachment or motor damage, troubleshooting

Method 1: Please check if the motor wires are in good contact. If they are in

good contact, please check if the motor has any odor or burnt smell. If this

problem occurs, the motor needs to be replaced.

This code is for overvoltage protection and burst protection. Troubleshooting

method: Check whether the input voltage matches the rated voltage of the

controller, check whether the displayed board mileage matches the

controller mileage. If powered on, immediately report an error. Please

replace the controller.

This code indicates an abnormal detachment or disconnection of the speed

communication control line between the upper and lower controls.

Troubleshooting method: Please check if the connector of the upper and

lower control lines is not in good contact or there is a disconnection

phenomenon. If there is a disconnection, please replace the connection line.