Advertenties
4.8.5.
Adjusting the lighting
Figure 30 - Correct lighting angle.
Tilt the front light q until the light beam shines as far ahead as possible but still touches the
ground so you can see as much of the road surface as possible, as indicated in Figure 30.
The rear light is mounted at a fixed angle and does not need to be adjusted. You can raise or
lower the front light to set the correct angle.
WARNING
6
Ensure that your front light is not angled at such a height that it shines directly into the eyes of
oncoming road users. This can dazzle them, which may lead to hazardous situations or accidents.
4.9. Configuring the on-board computer
WARNING
6
• Only configure the on-board computer when you are stationary in a safe place. Keep your
eyes on the road and surroundings at all times while cycling.
4.9.1.
General operation
Operate the on-board computer using the control unit next to the right handgrip on the
handlebars.
• Switch between the various screens with the and buttons.
• Adjust the values or settings with the and buttons.
• Confirm a choice or open the selected menu with .
1. Place the on-board computer 4 in the holder by following the instructions in chapter 4.6.
You can change the following settings in the "System" screen:
• Language
90
Advertenties
