Advertenties
Beschikbare talen
Beschikbare talen
7.3.2 LIST OF MAINTENANCE ACTIVITIES AND FREQUENCY
The table below shows the maintenance tasks, with their frequency.
CAUTION
The maintenance operations described below are to be carried out with the product stationary and power
switched off.
Check the total integrity of the product.
Check blade lubrication.
Check blade sharpness.
Check that the board contacts are undamaged and clean.
Check the integrity of the guards.
Check battery efficiency
Check that all screws are tightened correctly
Remove cutting debris from the blades.
Check blade wear.
Periodic overhaul to be carried out at a Manufacturer's
Technical Assistance Centre (T.A.C.)
Battery holding recharge. Necessary to prevent battery
from dropping below 10V (no longer rechargeable).
For details on the operating modes, please refer to this manual and in particular to par. 7.1 and 7.2.
With regard to any trade components installed on the product and for which specific documentation has been
provided, reference must be made to the aforementioned documentation for all activities.
7.3.3 RECOMMENDED LUBRICANTS AND ADHESIVES
The product has been designed in such a way as to reduce lubrication-related operations; however, due to its
inherent use, lubricants for the cutting part are required.
Characteristics of the greases and lubricating oils used
The data sheets for greases and lubricating oils in this section only contain the main technical characteristics
required for purchase, but not the safety information related to their use.
Before use, request the 'product safety data sheet' from the manufacturer, which can also normally be found on the
supplier's website.
Do not use any grease other than that indicated by the manufacturer where it is to be used.
Do not mix with other lubricants.
Careful use is recommended.
When handling/using grease, always use waterproof protective gloves and observe the safety data sheet of the
grease.
Be reminded that:
● inhalation of vapours generated by burning product at a temperature above 300 °C can lead to operator
malfunctions;
0310.0369_02
MAINTENANCE
ROUTINE
X
X
X
X
X
X
X
X
X
X
X
X
X
106
EXTRAORDINARY
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Advertenties
