5.1.1 STORAGE
The packaged product can normally be stored in a closed environment as long as the temperature is not lower
than -0 °C or higher than +50 °C (32-122 F) and the humidity does not exceed 80%.
No other packages must be placed on top of the packaging.
Special care must be taken for fragile materials.
Follow the position indications marked on the packaging.
Special care must be taken during loading, unloading, transport, so as to avoid shocks and damage.
Make sure that the packaging has not been damaged during these operations.
No damaged packaging shall be repaired by the customer.
CAUTION
It should be remembered that certain effects resulting from the exposure of a product to environmental conditions
are the direct consequence of its exposure in sequence to two or more factors or parameters, among which are
particularly critical:
➢ thermal shock, which may result from exposing the product to high temperature conditions immediately
after exposure to low temperature conditions or vice versa, or subjecting the product to water (rain, water
jets, snow, immersion, etc. all forbidden conditions) immediately after exposure to high temperature
conditions;
➢ the formation of ice, which may result from exposing the product to below-freezing temperatures
immediately before or after exposure to moisture, rain or water due to causes other than rain.
CAUTION
After storing the product within the limits of the above-mentioned conditions, it is required that it be kept in non-
operative condition for approximately 12 hours in order to re-establish the correct ambient temperature conditions
permitted (see paragraph 4.7) so as to avoid damage to the electrical/electronic part as a result of thermal shock,
ice formation or humidity, etc., which may deteriorate or damage these circuits.
5.2
PRODUCT ASSEMBLY
The product covered by this manual is supplied with the bar, chain and battery removed and the oil tank empty.
The following operations must be performed during the first use:
•
Chain tension adjustment. See paragraph 5.2.1.
•
Filling the oil tank and lubricating the chain. See paragraph 5.2.2.
•
Insert the supplied battery. See paragraph 5.2.3.
0310.0353_04
95